Only the encoder should move, not the shaft. Is mounted on is secure and does not move at all. Movement, the encoders can become loose, resulting in a bad connection. Use a voltage meter to verify that voltage varies as headset moves up and down or left and right. Make sure the DC power supply on/off switch is on. If you are using a USB hub, test the hub to make sure it is working properly.Ĭheck the DC power supply. If the USB Game Dongle is connected correctly it should light up with a Red LED.
To many Credits for Number of Coins InsertedĬheck coins per $ setting in the Operator Menu.Ĭheck to make sure the USB Game Dongle is connected to the USB port on the back of the computer. Confirm the HAPP UGCI card has power by looking for the Green LED.Ĭheck the signal wires between the coin mech and HAPP UGCI card. Confirm the HAPP UGCI card is connected to a USB port on the computer (not to a USB hub). Make sure the volume pot on the audio amp is not turned all the way down.Ĭheck that the signal and ground wires are connected to the Headset and buttons.
Make sure the audio amp has power make sure the DC power supply on/off switch is on. Make sure the audio cable is connected from the audio amp to the green audio port on the computer. Check for faulty Video Card in System Computer. Games must be installed in the following order:įaulty video cable, video card, or monitorĬheck for a loose or disconnected video cable. (Not applicable if you use the three-disk Game Install Set, Part # 050-0161-01) (See the Hardware Reference Page for detailed BIOS Setup instructions.) Look under Integrated Peripherals and make sure that PWR Lost Resume State is set to Turn On. If the computer only turns on when you press the power button on the computer, connect a keyboard and press the DEL key during boot to enter the BIOS Setup Utility. Confirm the power cord is plugged into a working AC outlet. Make sure the cabinet On/Off switch is on. Make sure the power cord is plugged into the computer and power strip, and the power strip is on. Verify the CD-ROM tray has fully closed and is not jammed.
Try ejecting the CD and re-Inserting it to re-activate the auto-install process. Look under Advanced BIOS Features and make sure that CDROM is set as the first boot device. Even if you do not own Invasion Earth, you must run the Invasion Earth Game Install Disk to load these drivers.)Ĭonnect a keyboard and press the DEL key during boot to enter the BIOS Setup Utility.
0 kommentar(er)
